A careful path from enquiry to installation

Each installation begins with the equipment and site—not a fixed installation-time promise. Scope and sequence are confirmed for the specific project.

Step 1 · Initial enquiry

Customer shares generator information, site location and requirement.

Step 2 · Generator assessment

Specifications, installation conditions and technical requirements are reviewed.

Step 3 · Compatibility and quotation

Potential configuration and installation proposal are evaluated against available evidence.

Step 4 · Installation planning

Approved device fitment is planned with qualified personnel using applicable technical and safety procedures.

Step 5 · Checks and handover

Installation checks, operational verification and customer guidance are completed as applicable.

Site readiness

Good preparation makes the assessment useful.

Share generator nameplate details, engine information, exhaust photographs or drawings, number of units and installation location where available.

Any proposed work is subject to confirmed compatibility, approved documentation, site conditions, scope and quotation.

Schedule a generator assessment

Before work is planned

Safety, access and technical coordination

Work scope depends on the selected model and site. Applicable safety procedures, equipment isolation, access, mounting, clearances, exhaust routing and customer coordination must be addressed in the project plan.

Installation timing, performance, warranty, service intervals and regulatory outcomes are not stated as fixed promises; confirm these details in the approved proposal and manufacturer documentation.

Start with your generator details.

Our enquiry form helps capture the information needed for a first review.

Share generator information